Changing temperature and spin
speed
The following parameters can be changed
before the start of a program:
–
the temperature in 1 °C steps from cold,
15 °C to maximum 95 °C .
–
the spin speed in 100 rpm steps from 0,
300 - 1200 rpm maximum.
PROGRAMME 11 COTTONS
>60°< Prewash 1
95 °C Main wash 1
Rinse 3 1200 RPM
^
Use the 2 "Cursor" to position the cursor
on the input field for the Prewash temp
-
erature, and set the temperature required
(here 60 °C) with the 3 4 "Minus or Plus".
^ Position the cursor on the input field for the
Main wash temperature, and set the
temperature required with 3 4 "Minus or
Plus".
^ Position the cursor on the input field for the
spin speed, and set the spin speed with
the 3 4 "Minus or Plus".
^ Press the X "Start" button to begin the
program.
Program sequence display
The program sequence is shown in the
display after the start of the program.
PROGRAMME 11 COTTONS
60° C Prewash 20 °C ^^^^^^^^
90° C Main wash
~
In the second display line, here Prewash, the
actual suds temperature is shown, and the
time line extending off to the right, under-
neath the next cycle of the program is
shown, here Main wash.
PROGRAMME 11 COTTONS
90 °C Main wash 20 °C
^^^^^^^^
Rinse 1PROGRAMME STOP
~
When the Prewash cycle has finished, the
Main wash appears in the display, with the
actual suds temperature, and the time line
extending off to the right. Underneath the
next cycle of the program is shown, here
Rinse 1.
When an arrow appears at the right of the
last line (~), this indicates that there is a
following display line.
Press the 2 "Cursor", and further information
on the program appears in the lower lines.
Program end display
After water from the last heating phase has
drained away, or after the last "Cool Down"
the program end time is shown in hours and
minutes.
PROGRAMME 11 COTTONS
Rinse 1
^^^^^^^^^
Rinse 2
Programme end 11:25 hrs ~
Operation
19
To Next Page
Loading...
