Removing the rear shipping struts
To remove the rear shipping struts, unscrew
the 13 screws and loosen the 15 lower torx
screws from the back panel.
,
Do not transport the washer without
these shipping struts in place.
Level the washer
The machine must be level to ensure proper
operation.
The machine can be leveled by turning the
legs clockwise or counterclockwise as
necessary.
^ the washer is levelled by adjusting the four
screw feet.
^ Use a multiple slip-joint gripping pliers to
hold the foot.
^ Unscrew each of the four feet as much as
necessary by turning both the foot and the
locking ring to the left using a screw driver.
,
The machine must not be moved
without all of the outer panels in place.
Installation Instructions
38
“B” “C”
To Next Page
Loading...
