Miele W 6071 - Fault Messages

Fault messages
,Repairs should only be carried out by a
qualified and trained person in accord
-
ance with local and national safety
regulations. Unauthorized repairs could
cause an injury or machine damage.
Faults that occur before or after the start of a
program flash in the display.
PROGRAMME 11 COTTONS
PROGRAMME STOP
THROUGH POWER CUT
Press "Start" to continue the program.
^
Once power is restored, press X "Start".
This fault message can also indicate: The
overload cut-out of the drive motors has over
heated. Allow the motor to cool down.
PROGRAMME 11 COTTONS
PROGRAMME STOP
WATER INLET FAULT
Open water stopcock and press Start button.
^ Open the water valve (stopcock) and
press X "Start".
PROGRAMME 11 COTTONS
PROGRAMME STOP
DRAIN FAULT
Check drain system and press Start button.
^
Check and clean the drain system and
press X "Start".
PROGRAMME 11 COTTONS
PROGRAMME STOP
HEATING SYSTEM FAULT
Short circuit on heat sensor 1.
^
Contact Technical Service.
PROGRAMME 11 COTTONS
PROGRAMME STOP
HEATING SYSTEM FAULT
Cut-out on heat sensor 1.
^
Contact Technical Service.
PROGRAMME 11 COTTONS
PROGRAMME STOP
HEATING SYSTEM FAULT
^
Contact Technical Service.
PROGRAMME 11 COTTONS
PROGRAMME STOP
DRIVE SYSTEM FAULT
Multiplug drive variants failure.
^
Contact Technical Service.
PROGRAMME 11 COTTONS
90 °C Main wash 20 °C
Rinse 1
DRIVE SYSTEM FAULT
^ Contact Technical Service. if there is no
drum movement after this message.
PROGRAMME 11 COTTONS
PROGRAMME STOP
IMBALANCE SWITCH
Press the On-Off switch.
^ Press Z "Power off" and Y "Power on".
PROGRAMME 11 COTTONS
PROGRAMME STOP
PRESSURE MONITOR FAULT
^
Contact Technical Service.
PROGRAMME 11 COTTONS
PROGRAMME STOP
DISPENSING SYSTEM FAULT
Dispensing container 1 empty
^
Change the dispensing container.
Frequently asked questions
31