5. Start the programme
26
To start a programme
Touch the flashing Start/Stop sensor.
The door will lock (the symbol will
appear in the control panel to show this)
and the programme will start.
If a delay start time has been selected,
then this will count down in the time
display. At the end of the delay start
time or immediately after the pro-
gramme has started (if no delay start
time has been selected), the pro-
gramme duration will appear in the time
display.
Energy savings
After 10 minutes, the indicators dim and
the Start/Stop sensor starts flashing.
Touch the Start/Stop sensor to switch
the indicators on again (this does not
have any effect on a running pro-
gramme).
To Next Page
Loading...
Need help?
General