Miele WDB 030 - Control Panel Switch-Off Status; Washing Machine Switch-Off Status; Memory

Programmable functions
72
 Control panel switch-off
status
To save energy the time display and
sensors will go out after 10 minutes,
and only the Start/Stop sensor will
flash slowly.
Options
 = Off
The time display and sensors
will remain lit up while the
washing machine is switched
on
 = On (factory default setting)
The time display and sensors
will switch off after 10 minutes
if
– no further selection is made
after switching the machine
on
– the programme is started
However; the time display and
sensors will remain lit up for 10
minutes after a delay start time
has elapsed, after the end of
the programme or at the end of
the anti-crease phase.
 Washing machine switch-
off status
The washing machine will switch off
automatically after the end of the pro-
gramme/anti-crease phase or after be-
ing switched on if no further selection
is made.
Options
 = The washing machine will
switch itself off after 15
minutes (factory default set-
ting)
 = The washing machine will
switch itself off after 20
minutes
 = The washing machine will
switch itself off after 30
minutes
 Memory
The washing machine will save the
last settings (temperature, spin speed
and some of the extras) selected for a
programme after the programme has
started.
When this programme is chosen again,
these saved settings will appear in the
display.
Options
 = Memory is switched off (fact-
ory default setting)
 = Memory is switched on