To Next PageTo Next Page
Need help?Do you have a question about the Migatronic OMEGA2 300 and is the answer not in the manual?
General| Input Voltage | 3 x 400 V |
|---|---|
| Mains Frequency | 50/60 Hz |
| Duty Cycle 60% at 40°C | 300 A |
| Weight | 26 kg |
| Protection Class | IP23 |
| Standards | EN 60974-1, EN 60974-10 |
| Power Source | Inverter |
| Rated Input Voltage | 400 V |
Procedures for unpacking and safely lifting the welding machine.
Guidelines for electrical connection and shielding gas setup.
Steps for connecting the welding hose.
How to estimate material consumption based on welding parameters.
Steps for assembling components within the wire feed unit.
How to adjust the wire brake for proper wire feeding.
Procedures for torch adjustment and wire inching function.
Guidance on selecting the correct welding polarity.
Process for reading and updating machine software via SD card.
Procedure for calibrating the wire feed speed.
Method for controlling the wire feed speed.
How to activate and use the lock function.
Steps to view the installed software versions.
List of error codes with corresponding causes and solutions.
Interpretation of various fault symbols.
