Do you have a question about the MikroTik RouterBOARD SXT 5HnD and is the answer not in the manual?
Brand | MikroTik |
---|---|
Model | RouterBOARD SXT 5HnD |
Category | Wireless Access Point |
Language | English |
Information protected by copyright law; reproduction or transmission requires permission.
Lists trademarks of MikroTikls SIA and other registered trademarks.
Covers defects for 15 months, excluding damage from misuse or external factors.
Instructions for returning failed units; contact reseller or MikroTik directly.
Out-of-warranty devices returned at sender's cost.
Visual representation of the SXT's internal components.
Labeled diagram of components on the SXT system board.
Details CPU, Memory, Storage, Ethernet, Wireless, Antenna, ESD, MiniPCI, Serial, LEDs, Extras.
Specifies power options, compatibility with passive PoE, and voltage range.
Describes the LAN1 port's functionality and compatibility with passive Power over Ethernet.
Explains the function and behavior of the Power LED, User LED, and wireless signal strength LEDs.
Details the built-in 802.11a/n 5GHz wireless device and its specifications.
Describes the dual polarization 5GHz antenna, frequency range, gain, and beam width.
Explains the USB 2.0 port and its support for RouterOS USB power reset.
Steps for initial device setup, connection, and configuration.
Recommendations for grounding and details on powering the device via PoE.
Guidance on how to physically mount the SXT device, including orientation.
Explains RouterBOOT loader and booting from NAND or network.
How the device boots from its onboard NAND storage, including file structure.
Details network boot process using PXE/EtherBoot, TFTP, BOOTP/DHCP.
Describes RouterBOOT firmware's role in booting the OS and its configuration.
How to configure and upgrade the boot loader using RouterOS commands.
Information on supported MikroTik RouterOS versions and potential issues with downgrading.
Details the pinout for the RJ45 Fast Ethernet 100Base-TX port (LAN1) with PoE.
Details the functions of the S1400 button and the RESET jumper.
Provides pinout information for straight and crossover Ethernet cables.
FCC rules for the device, including interference, exposure limits, and caution statements.