EasyManua.ls Logo

Mile Marker SEC15 - WINCH MAINTENANCE; Maintenance Recommendations; TROUBLESHOOTING; Troubleshooting Common Issues

Default Icon
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
WINCH MAINTENANCE
TROUBLESHOOTING
All moving parts within the electric winch have been lubricated using high temperature lithium grease at the factory. No further internal
lubrication is required for the life of the winch.
•If using steel cable, lubricate the steel cable periodically using light penetrating oil
Electrical connections may corrode over a period of time due to environmental changes. This may result in reduced performance of the winch
or even possible electrical shorting. Hence, always clean the electrical connections before and after using the winch.
•After every use of the winch, inspect the steel cable/synthetic rope for damages such as kinks, broken strands etc. When damaged, replace the
cable immediately.
Symptom Possible Cause Suggested Remedy
Motor does not turn on
Safety switch is OFF Turn safety switch ON
Switch assembly not connected
properly
Insert switch assembly firmly to the connector
Loose battery cable Tighten nuts on cable connectors
- Connection
- Solenoid malfunctioning
Tap solenoid to free contact, applying 12 volts
to coil terminal directly. An audible clicking
will occur when activating.
Defective switch assembly Replace switch assembly
Defective motor
Check for voltage at armature port with switch
pressed. If voltage is present,
replace motor.
Water has entered motor
Drain and dry. Run in short bursts without load
until completely dry.
Motor runs too hot Long period of operation Let winch cool down periodically
Motor runs slowly or
without normal power
Battery runs down Recharge battery by running vehicle engine
Insufficient current or voltage Clean, tighten or replace the connector
Motor runs but cable
drum does not turn
Clutch not engaged
Turn clutch gear to IN/ENGAGED position - if
that does not work, ask a qualified technician
to check and repair
Motor runs in one
direction only
Defective or stuck solenoid
Tap solenoid to free contacts. Repair or replace
solenoid.
Defective switch assembly Replace switch assembly
2121 Blount Road Pompano Beach, FL 33069 MileMarker.com 1.800.886.8647PAGE 11

Related product manuals