Milesight LoRaWAN WS101 - Lorawan Settings

7
2) If the smartphone fails to read/write configurations via NFC, move the phone away and back
to try again.
3) WS101 can also be configured by ToolBox software via dedicated NFC reader provided by
Milesight IoT, you can also configure it via TTL interface inside the device.
3.3 LoRaWAN Settings
LoRaWAN settings are used for configuring the transmission parameters in LoRaWAN
®
network.
Basic LoRaWAN Settings:
Go to Device -> Setting -> LoRaWAN Settings of ToolBox App to configure join type, App EUI,
App Key and other information. You can also keep all settings by default.
Parameters
Description
Device EUI
Unique ID of the device which can also be found on the label.
App EUI
Default App EUI is 24E124C0002A0001.
Application Port
The port used for sending and receiving data, default port is 85.
Join Type
OTAA and ABP modes are available.
Application Key
Appkey for OTAA mode, default is 5572404C696E6B4C6F52613230313823.
Device Address
DevAddr for ABP mode, default is the 5
th
to 12
th
digits of SN.
Network Session
Key
Nwkskey for ABP mode, default is 5572404C696E6B4C6F52613230313823.
Application
Session Key
Appskey for ABP mode, default is 5572404C696E6B4C6F52613230313823.