Milestone Husky - Administrator Manual
Enable or disable (see "About motion detection" on page 61) the
built-in motion detection.
Turn the grid on and off.
Turning the grid off may provide a less obscured view of the
preview image. You select the areas to exclude from motion
detection the same way as when the grid is visible. When the grid
is turned on, the preview image is divided into small sections by a
grid.
To define areas which should be excluded from motion detection,
drag the mouse over the areas in the preview image while
pressing the mouse button down. The left mouse button selects a
grid section and the right mouse button clears a grid section.
Selected areas are highlighted in blue.
Quickly select all grid sections in the preview image. This can be
useful if you want to exclude motion detection in most areas of
the image, in which case you can clear the few sections in which
you do not want to exclude motion detection.
Clear all grid sections in the preview image.
Enable this functionality to adjust the Sensitivity slide for motion
yourself.
Drag the slider to the left for a higher sensitivity level, and to the
right for a lower sensitivity level.
The higher the sensitivity level, the less change is
allowed in each pixel before it is regarded as motion.
The lower the sensitivity level, the more change in each
pixel is allowed before it is regarded as motion.
Pixels in which motion is detected are highlighted in green in the
preview image.
Milestone recommends that you do not enable manual sensitivity
because:
With dynamic sensitivity, the system calculates and
optimizes the sensitivity level automatically and suppresses
motion detections that come from noise in the images.
Dynamic sensitivity improves motion detection at
nighttime, where the noise in the images often triggers false
motion.
The system is not overloaded from too much recording.
The users are not missing results from insufficient
recording.
To Next Page