Milestone Husky - Administrator Manual
If you later want to remove an output from the one of the lists, select the output in question, and
click the << button.
Motion detection & exclude regions
When you configure video and recording (see "About video and recording configuration" on page
60) for specific cameras, adjusting motion detection is important because it may determine when
video from the camera is recorded, when email notifications are generated or when hardware
output, such as lights or sirens, is activated. Time spent on finding the best possible motion
detection settings for each camera may help you later avoid unnecessary recordings and
notifications. Depending on the physical location of the camera, it may be a very good idea to test
motion detection under different physical conditions such as day/night or windy/calm weather.
Before you configure motion detection for a camera, you should configure the camera's video
properties (see "General" on page 85) including compression and resolution.
Cameras that do not support multiple simultaneous video streams cannot connect to the
surveillance server and the Management Application at the same time. Milestone recommends that
you stop (see "Start and stop services" on page 172) the Recording Server service when you
configure such devices for motion detection and PTZ.
See also View video from cameras in the Management Application.
To Next Page