MILESTONE
USER MANUAL
ETHOS EZ User manual MA073-006 Terminal chapter Page - 80 -
Do you really want to leave this page ?
43 The flash card already contains a signature.
Do you really want to overwrite the existing
signature ?
Security question before writin
a si
nature on a Flash
Card, which already contains a Si
nature. The existin
signature is overwritten.
44 Error when writing signature to card. An error occurred during writing a Signature on the
Flash Card. The cause may be a defective or full Flash
Card (see Chapter Flash Card).
48 Your Flash Card does not have any signature.
Please contact your administrator.
The unit is set in Login-Mode „ with Flash Card“. The
inserted Flash Card does not have any signature.
56 You can change only to this mode if a
flash card with a signature for service
or administrator is inserted.
The Login-Mode can only be selected with a Flash Card
with Service or Administrator Signature.
57 The image could not be saved.
Please check if the flash card is present.
Does the card have enough memory to store
the image?
An error occurred durin
savin
of the current pro
ram
on a Flash Card. The Flash Card is not inserted, is
defective or full.
History Trail
Nr. Text Description/Remarks
18 The system couldn't save the changes
to the history trail. Please check your
trail file.
he chan
es of the system settin
s are saved. An error
occurred. Service must check the history trail of the
system.
54 The system recommends you to purge
your history trail. Only former entries
and user logins will be removed.
The internal memory is almost full of entries. The
Administrator should purge the history trail (see
corresponding chapter).
After purging 100 entries will still remain.
36 Do you really want to delete
all protocol information ?
Security question before deletin
the history trail in the
dosPREP
application.
Others
Nr. Text Description/Remarks
17 The MWB-640 in your system is not up to date:
software version 2 (necessary 3)
hardware version 2 (necessary 2).
This is not sufficient for this panel.
Please inform your local service partner.
The Interface-board of the microwave unit (MWB-640)
has not available the necessary software revision. This
configuration error an occur when replacing the
terminal with different software version.
Contact your local service.
20 Your license number is invalid.
Please enter a correct license key
or contact your next service partner
Your license key is invalid (see Chapter Panel Control).
Contact your local service.
41 There is no printer available!
Please check the connection cables
und power supply of your printer.
No printer is connected or the printer is not supported
by the Software (see Chapter Printer)
To Next Page
Loading...
