6.10 Utility menu
Adjusting device settings
In this menu, you can change various settings of the device.
1. Press [KIT].
ð
The display shows the kit list.
2.
Press [MENU]. Use the arrow buttons ( / ) to select the option ‘UTILITY’ and press [ENTER].
ð
The display shows the list of utility parameters.
3.
Use the arrow buttons ( / ) to select the parameter to be changed.
4. Use the arrow buttons ([<] / [>]) or the jog wheel to change the parameter value. Please note the information in the table
below.
5. Press [EXIT] to save the changes and to exit the menu.
Parameter, display Meaning Value range
GM MODE Defines the processing of programme change commands: ON: Programme
change commands for MIDI channel 10 are processed as selection (GM kit).
OFF: Programme change commands for MIDI channel 10 are processed as
selection (local kit).
ON, OFF
LOCAL CTRL ON: Drum module and MIDI sound are present at the output. OFF: Drum
module is muted, only MIDI sound.
ON, OFF
L-R EXCHANG Allows to switch from left-handed to right-handed configuration of the
entire set without having to change the wiring.
ON, OFF
AUTO POWER Defines the behaviour of the automatic shutoff:
n
‘30’ (automatic shutoff after 30 minutes)
n
‘60’ (automatic shutoff after 60 minutes)
n
‘OFF’ (automatic shutdown off).
30, 60, OFF
Operating
e-drum module
22
To Next Page
Loading...
