5
Genuine Miller Accessories
(continued)
MIG/Flux Cored Welding
SuitCase
®
X-TREME
™
8VS Wire Feeder
#951 182
SuitCase
®
X-TREME
™
12VS Wire Feeder
#951 184
Lightweight, portable, voltage-sensing
wire feeders include secondary contactor
and gas valve and drive roll kit. See Lit.
Index No. M/6.41.
SuitCase
®
8RC Wire Feeder #951 186
SuitCase
®
12RC Wire Feeder #951 188
Lightweight and flexible enough to run a
variety of wires up to .062 in diameter.
Includes remote voltage control and drive
roll kit. See Lit. Index No. M/6.5.
Spoolmatic
®
30A Spool Gun #130 831
Air-cooled, 200-amp, 1-lb spool gun for
aluminum MIG. See Lit. Index No. M/1.73.
WC-24 Control #137 549
Use with Spoolmatic 30A.
XR
™
Wire Feeders and Guns
Push-pull system designed to handle
difficult-to-feed soft alloy wires such as
aluminum. See Lit. Index No. M/1.7,
M/1.71, and M/1.73.
TIG (GTAW) Welding
Dynasty
®
200 Series
For premium portable AC/DC TIG arc
quality. See Lit. Index No. AD/4.8.
HF-251 Series #042 388
HF-251D-1, 115 VAC
High-frequency arc starter and stabilizer.
See Accessory Lit. Index No. AY/5.0.
Remote Controls
RHC-14 Hand Control #242 211 020
Miniature hand control for remote current
and contactor control. Dimensions: 4 x 4 x
3-1/4 in (102 x 102 x 82 mm). Includes
20 ft (6 m) cord and 14-pin plug.
RFCS-14 HD Foot Control #194 744
Heavy-duty foot control for current and
contactor control. Includes 20 ft (6 m) cord
and 14-pin plug.
RMLS-14 #129 337
14-pin plug Momentary- and maintained-
contact rocker switch for contactor control.
Push forward for maintained contact and
back for momen tary contact. Includes 20 ft
(6 m) cord.
RCC-14 Remote Contactor and Current
Control #151 086 14-pin plug
Rotary-motion fingertip control fastens to
TIG torch using two Velcro
®
straps.
Includes 28 ft (8.5 m) control cord.
Extension Cords for 14-Pin
Remote Controls or 24 VAC Wire Feeders
#242 208 025 25 ft (7.6 m)
#242 208 050 50 ft (15.2 m)
#242 208 080 80 ft (24.4 m)
To Next Page