OWNER’S MANUAL
© 2010 MILLER Electric Mfg. Co.
OM-823 029 899V
2010−05
RHC-3, RHC-3GD34A, And
RHC-14 Remote Hand Controls
DANGER! − Indicates a hazardous situation which, if not
avoided, will result in death or serious injury. The possible
hazards are shown in the adjoining symbols or explained
in the text.
Wear safety glasses with side shields.
Indicates a hazardous situation which, if not avoided,
could result in death or serious injury. The possible ha-
zards are shown in the adjoining symbols or explained in
the text.
Arc rays can burn eyes and skin − wear a welding helmet
with correct filter, and cover exposed skin with nonflam-
mable clothing.
NOTICE
Indicates statements not related to personal injury.
Indicates special instructions.
Welding sparks can cause fire or explosion. Move flam-
mables away. Do not weld on closed tanks or barrels −
they can explode. Clean tanks or barrels properly.
Beware of electric shock from welding electrode or wiring.
Touching the electrode while in contact with the work or
ground can cause electric shock. Always wear dry
gloves. Keep all panels and covers closed.
Breathing welding fumes and gases can harm your
health. Welding requires good ventilation. If ventilation is
impossible, such as when welding in a confined space,
use an air-supplied respirator.
CALIFORNIA PROPOSITION 65 WARNINGS
Welding or cutting equipment produces fumes or gases which contain chemicals known to the State of California to cause birth defects and, in
some cases, cancer. (California Health & Safety Code Section 25249.5 et seq.)
This product contains chemicals, including lead, known to the state of California to cause cancer, birth defects, or other reproductive harm.
Wash hands after use.
1. Specifications And Connections
141 127-A
1 Twistlock Plug
2 5- Or 14-Pin Amphenol Plug
Units are equipped with a 20 ft
(6 m) cord. If a longer cord is required, see
Section 2.
A 7-1/2 in.
(191 mm)
B 9-1/2 in.
(241 mm)
C 8-3/4 in.
(222 mm)
B
C
A
1
2
To Next Page
Need help?
General
