7
SECTION II
INTRODUCTION
This technical manual provides details of the set up and calibration procedures for the control as well as
providing information about the interfacing of the system with other 9700 series controls and ancillary
controls. It also provides troubleshooting and maintenance information.
The 9700W microprocessor controller has been developed to provide high quality, precision wire feed
control. The quality design and workmanship of this control will provide many years of dependable service.
The 9700W control includes a motor controller and can therefore be connected directly to the wire feed
motor. It is used for motors up to ½ HP of the type used on Miller Welding Automation standard wire feed.
It provides wire feed accuracy levels suitable for most conventional applications.
Modes of operation are:
Operator Mode:
This is the mode used by the welding operator to run the unit. It permits the wire feed speed, start and stop
delays to be adjusted.
Configuration Mode:
This mode is used to set up of the unit for specific applications. It permits the setting of the wire feed
speeds, and interface with other control boxes and features are used in a dedicated system.
Calibration Mode:
In this mode, the closed loop can be turned on and off, the unit can be set for inch or metric units and the
calibration can be checked and set.
To Next Page
Loading...