14
WIRE STOP DLY
If the wire is started by the external contact this is how long after
the contact has been removed before the wire will start begin
retract. Otherwise retracts starts when stop is pressed. Minimum
value is 0.0, Maximum value is 10.0.
RAMP TIME
After the wire starts feeding, this is the time the wire will ramp up
from 0.0 to its programmed speed. This is most likely used in hot
wire applications when high wire speeds are used to ramp wire
with the heat put into the part. The line will only appear if
Configuration Mode / Ramp Enable is Yes. Minimum value is
0.0, Maximum value is 10.0.
AUX1 PROGRAM SUB MENU SCREEN
If the right button is pressed you will go into the AUX1 sub menu.
This screen will only appear if Configuration Mode / AUX1 name
has been assigned a name and then that name will appear in the
menu. See AUX1-3 section for details of this sub menu.
AUX2 PROGRAM SUB MENU SCREEN
If the right button is pressed you will go into the AUX2 sub menu.
This screen will only appear if Configuration / AUX2 name has
been assigned a name and then that name will appear in the
menu. See AUX1-3 section for details of this sub menu.
AUX3 PROGRAM SUB MENU SCREEN
If the right button is pressed you will go into the AUX3 sub menu.
This screen will only appear if Configuration / AUX3 name has
been assigned a name and then that name will appear in the
menu. See AUX1-3 section for details of this sub menu.
To Next Page
Loading...