. A complete Parts List is available at www.MillerWelds.com
OM-283935 Page 34
6-2. Special Features
A. MIG Mode
In MIG mode, the left knob is used to adjust welding voltage within a range of 12 to 32 volts. The right knob is used to adjust wire feed speed within a
range of 60 to 600 IPM. Refer to weld chart inside the wire drive compartment for proper parameter settings according to wire type, shielding gas, and
material type and thickness.
B. Jog Mode
If gun trigger is pressed and held for more than 3 seconds without striking an arc, unit will automatically shut off weld power and shielding gas. After one
minute the wire will stop and a trigger error will be displayed. Release trigger.
C. Weld Status
When the arc is extinguished, the last actual amperage and voltage are shown on the display for 5 seconds. If a preset value requires adjustment after
the arc is extinguished and during the 5-second display of actual values, turning either knob will cause actual values in the displays to be replaced by
preset values for adjustment purposes.
D. MIG Gun-On-Demand
MIG guns and spool guns can be used with this unit. To switch from one gun to another, momentarily press the trigger on the desired unused gun to
make it the active gun. Once the trigger is pressed, the unit will recall stored data and both displays will show the last programmed values for that
particular gun. If the unit is powered down and back on again, the gun last used will become the current active gun.
Notes
To Next Page
Loading...
Need help?
General
