Miller S-74 MPa Plus - Default Chapter; Table of Contents

TABLE OF CONTENTS
SECTION 1 − SAFETY PRECAUTIONS - READ BEFORE USING 1.................................
1-1. Symbol Usage 1.......................................................................
1-2. Arc Welding Hazards 1.................................................................
1-3. Additional Hazards For Installation, Operation, And Maintenance 3.............................
1-4. California Proposition 65 Warnings 4......................................................
1-5. Principal Safety Standards 4.............................................................
1-6. EMF Information 4.....................................................................
SECTION 2 − CONSIGNES DE SÉCURITÉ − LIRE AVANT UTILISATION 5...........................
2-1. Symboles utilisés 5.....................................................................
2-2. Dangers relatifs au soudage à l’arc 5......................................................
2-3. Dangers supplémentaires en relation avec l’installation, le fonctionnement et la maintenance 7.....
2-4. Proposition californienne 65 Avertissements 8..............................................
2-5. Principales normes de sécurité 8.........................................................
2-6. Informations relatives aux CEM 8.........................................................
SECTION 3 − DEFINITIONS 9..................................................................
3-1. Additional Safety Symbols And Definitions 9................................................
3-2. Miscellaneous Symbols And Definitions 11..................................................
SECTION 4 − SPECIFICATIONS 12..............................................................
4-1. Serial Number And Rating Label Location 12................................................
4-2. Unit Specifications 12....................................................................
4-3. Environmental Specifications 12...........................................................
SECTION 5 − INSTALLATION 14................................................................
5-1. Selecting A Location 14..................................................................
5-2. Equipment Connection Diagrams 15.......................................................
5-3. Rear Panel Connections And Rotating Drive Assembly 16.....................................
5-4. 14-Pin Plug Information For Connecting Wire Feeder To Power Source 17........................
5-5. Wire Type, Size, And Optimal Wire Feed Speed Table 17......................................
5-6. Installing Welding Gun 18................................................................
5-7. Installing And Threading Welding Wire 19...................................................
SECTION 6 − OPERATION 20...................................................................
6-1. Power Switch 20........................................................................
6-2. Jog/Purge Switch 20....................................................................
6-3. Front Panel Controls 21..................................................................
6-4. Left Display 22.........................................................................
6-5. Right Display 22........................................................................
6-6. Adjust Control Left/Right 23...............................................................
6-7. Setup Push Button 23...................................................................
6-8. Start Push Button 23....................................................................
6-9. Crater Push Button 23...................................................................
6-10. Program Select Push Button 23...........................................................
6-11. Power Source Selection Menu 24..........................................................
6-12. Operational Terms 25....................................................................
SECTION 7 − SETTING SEQUENCE PARAMETERS 26............................................
7-1. Sequence Parameters In A Program 26.....................................................