Millipore Milliflex Plus - 2. Hub Installation

10
2. Hub installation
The VHP Compatible Milliex
®
PLUS Pump Hub is used to connect the uidic tubes and electrical cables from
up to three Milliex
®
PLUS pumps.
• Fluid Line Connections
Push the Milliex
®
PLUS Pump uid line connectors
into the uid hub until a click is heard. Install the
other end of the tubing onto the pumps.
Insert the output tubing onto the stainless
steel connector.
To disconnect the uid lines, push on the button
and pull the connector.