CHAPTER 6 - MAINTENANCE
Spindle Bearing Maintenance (some models)
Maintenance of the Spindle Bearing Grease
for Large Spindle Bore Lathes
(Applies to all 10” bore and above, and 6” bore w/ tapered roller bearings)
1 2
• Use only Kluber STABURAGS NBU 8 EP
grease or equivalent.
• Spindle should be greased 3 months after machine commissioning, then every 6 months
thereafter.
• Apply 30CC of grease at each of the lubrication points for spindle bores under 14”.
Spindle bores 14” and above require 50CC.
• Apply grease to fittings at points 1 and 2 at the top of the lathe headstock.
• To apply grease:
Power off the machine.
Turn spindle by hand as the grease is applied.
Klüber Lubrication North America L.P.
32 Industrial Drive
Londonderry, N.H. 03053
Tel: +1-603-647-410 4
+
-
-
-
49
To Next Page
Loading...
Need help?
General
