Milltronics VM25 Instruction Handbook

C HAPTER 4 - I NSTALLATION
25
Air Supply System
Milltronics machining centers require a constant supply of quality air pressure in order to
perform optimally. 90-110 PSI at 10 CFM is required for VM15 through VM30 models.
Adjustments
• Set the main air regulator to 90 PSI.
• Do not adjust the air purge regulator unless instructed to do so by an authorized
Milltronics Representative.
• Set the drop rate on the lubricator to approximately 1 drop per every 1-2 tool
changes
Spindle air pressure
gauge. Do not alter
from factory setting.
Maintain fill
levels weekly
using specified
air tool oil.
Main air pressure
gauge. Adjust
using knob “A”.
90 PSI
A
B
Water trap is self-
draining. No need
to drain manually.
Fill with Marvel
No.085, Mobil
Velocite No. 10
or equivalent oil.

Milltronics VM25 Specifications

General

Brand	Milltronics
Model	VM25
Category	Industrial Equipment
Language	English