Milnor 60044SP2 - Page 28

Chapter 3. Routine Maintenance
PELLERIN MILNOR CORPORATION
Table 5: Components that Become Worn
Examine. Tighten or replace if necessary, to prevent shutdowns and unsatisfactory performance.
Speak to your dealer for replacement parts
Mark
1
2 3 4 5 6
Do this each
Component More Data
x 200 hours drive belts and pulleys See Supplement 1 and Figure 7
x 200 hours tubes and hoses Examine hoses and hose connections for
leaks.
x 200 hours cylinder door latches These components must be serviceable for
safe operation. See Figure 18
x 200 hours Staph barriers—Staph Guard
®
models only: internal barrier,
flapper valve, and barrier
around machine (by others)
These components must be serviceable to
prevent air movement from the soil side to the
clean side. See Figure 19
24