- 4 -
© 2021 MIMAKI ENGINEERING CO.,LTD.
12 Push the main unit to the front side and fix it to
the leg with 2 screws (M5x16).
• Push the main unit toward the front side until there is
no gap between the protrusion on the rear side of the
leg and the insertion hole on the bottom of the main
unit and secure it.
• Set the other side in the same way.
13 Fully tighten the screws on the leg stay.
14 Remove cushioning materials.
Turn the roll bar manually to ensure it rotate
smoothly. If it gets stuck or has trouble rotating,
loosen the screws that have been tightened,
adjust the left and right legs so that they are
parallel, and then tighten the screws.
Front
No gap
To Next Page
Loading...
