Need help?Do you have a question about the MIMAKI CG-130FXII and is the answer not in the manual?
General| Type | Cutting Plotter |
|---|---|
| Maximum Cutting Width | 1300 mm |
| Cutting Speed | 1000 mm/s |
| Repeatability | ±0.1 mm |
| Power Supply | AC 100-240V, 50/60Hz |
| Weight | 75 kg |
| Maximum Media Width | 1370 mm |
| Maximum Cutting Area | 1300 mm x 50 m |
| Cutting Force | 30 - 500 gf |
| Maximum Cutting Force | 4.9 N (500 gf) |
| Media Thickness | 0.1 mm |
| Interface | USB, Ethernet |
| Operating Temperature | 5 - 35 °C |
| Operating Humidity | 35 - 80 % |
| Power Requirements | AC 100-240V, 50/60Hz |
Explains the structure and purpose of the operation manual.
Describes the high-accuracy mark-detection sensor.
Details the function of the newly developed roll stopper.
Explains the mechanism for changing clamp pressure modes.
Describes the features of the new cutter holder design.
Explains the ability to load media from the front.
Specifies the maximum number of roll sheets that can be set.
Mentions the included software for cutting characters and illustrations.
Describes the function for automatic cutting of sheets.
Explains hazard and warning symbols used in the manual.
Details actions to avoid, handling abnormal events, and power cable safety.
Covers environmental requirements and placement guidelines.
Provides safety guidelines for operating the device.
Explains the meaning and importance of safety labels on the device.
Lists and describes all included accessories with quantities.
Details the plotter's parts and their functions.
Instructions for using the scale seal for measurement.
Guide for connecting power and data interface cables.
Explains the different operational modes (Not-Ready, Local, Remote, Function).
Outlines the sequence of operations from power-on to completion.
Step-by-step guide for installing cutting blades and pens.
Instructions for safely turning on the plotter.
Details how to configure parameters for different tools and operations.
Procedures for loading both sheet and roll media.
How to perform test cuts to verify settings.
Steps to initiate the cutting or plotting process.
Instructions for safely shutting down the plotter.
Describes operations controlled via jog keys.
Explains functions accessed through dedicated keys.
Details various operational functions like test cutting and data output.
Covers how to configure various device settings.
Addresses user-reported issues and their solutions.
Details error codes, their causes, and corrective actions.
Explains non-error messages requiring user intervention.
Technical details and performance metrics of the device.
Guidelines for achieving accurate and repeatable results.
Procedures for replacing and adjusting the cutting blade.
Guidance for noting sheet types and correction values.
Visual diagrams illustrating key function sequences.
To Next Page