– 3.72 –
Set Over-cut Function [OVER CUT]
Set the availability of the over-cut function and the length of over-cutting.
When the length of over-cutting is specified, it starts to cut from the potion front by the specified
length, and then stops at the position back by the length.
Setting value
OFF, 0. 1 to 1.0mm (by 0.1mm)
* The cutting remainder at the start and end position, specially for flexible
media, can be adjusted by setting proper over-cutting, however it may cause
damage to the media if the over-cutting is set excessively.
OVER CUT: OFF
OVER CUT: 1.0 mm
1.0 mm
1.0 mm
To Next Page
Loading...
