To Next Page

To Previous Page

Chapter 1 Before Using This Machine

This chapter

Describes items such as the individual part names with which operators should familiarize

themselves before using this machine.

Preparation......................................................16

Assembling the Legs and Sheet Basket .... 16

Attaching the cutter guard.......................... 16

Installing Cutting Software and Plotter Driver

................................................................... 20

Installing the Firmware Updater ................. 21

Part Names and Functions..............................23

Front........................................................... 23

Rear ........................................................... 25

Carriage ..................................................... 27

Pinch Rollers and Grit Rollers .................... 28

SHEET sensor ........................................... 28

Clamp......................................................... 28

Tray ............................................................ 29

Operating panel.......................................... 30

Connect host computer to machine..................33

Using a USB Cable ......................................33

Using a LAN Cable ......................................33

Using an RS-232C Cable.............................34

Connecting the Power Cable............................36

Turning On the Power..................................38

Turning Off the Power..................................38

System Configuration .......................................40

MIMAKI CG-AR Series User Manual

Other manuals for MIMAKI CG-AR Series