This chapter
describes procedures and setting methods for ink and media preparation, tool installation
for cutting, and printing and cutting.
User Type for Printing ................................ 2-2
Settings That Can Be Registered in
User Types .................................................. 2-2
Using the Registered User Types ............... 2-2
About Tool Conditions during Cutting ..... 2-3
Tool Condition Types and Their Selection
Method ........................................................ 2-3
Registering a Tool Condition ....................... 2-4
Improving cutting quality ............................. 2-6
Operation Flow............................................ 2-7
Turning the Power ON/OFF........................ 2-8
Turning the Power ON ................................ 2-8
Turning the Power OFF ............................... 2-9
Installing Tools.......................................... 2-10
When a Cutter Is Used .............................. 2-10
Exchanging tool ......................................... 2-13
How to Attach a Ballpoint pen ................... 2-14
Setting a Medium ...................................... 2-15
Adjusting the Head Height ........................ 2-15
Adjusting the Position of the Pinch Roller
According to the State of a Medium .......... 2-17
Roll Stopper .............................................. 2-22
Maximum Print Area/Cut Area .................. 2-23
Notes When Using Medium Holder ........... 2-24
Setting a Roll Medium ............................... 2-25
Take-up Device ..........................................2-29
Setting a Leaf Medium ...............................2-31
When Changing the Origin ........................2-33
Test Printing .............................................. 2-35
Test Printing ...............................................2-35
Performing Head Cleaning ........................2-36
Performing Media Correction and Dot
Position Correction ....................................2-36
Test Cutting ............................................... 2-37
Preparing for the Heaters ......................... 2-38
Changing the Temperature Settings for
the Heaters ................................................2-38
Checking the Heater Temperature ............2-39
Printing Data.............................................. 2-40
Starting a Printing Operation .....................2-40
Stopping a Printing Operation ....................2-41
Deleting Received Data (Data Clear) ........2-41
Data Cutting............................................... 2-42
Starting a Cutting Operation ......................2-42
Stopping cutting in a while .........................2-42
Restarting a Cutting Operation ..................2-42
Stopping a Cutting Operation (Data Clear) 2-43
Removing the Cutter Unit Temporarily ......2-43
Cutting a Medium ...................................... 2-44
Chapter 2
Basic Operations
To Next Page
Loading...
