MIMAKI CJV30-130 - When Changing the Origin

2-33
Setting a Medium
2
Basic Operations
When Changing the Origin
The position of the print origin can be changed.
Move theprint origin to the intended position and determine the origin position.
1
In LOCAL, press the
keys.
• LOCAL changes to the origin setting mode.
2
Pressing the to set origin to the
intended position.
• Select the carriage and medium, moving the point with the
.
3
After determining the origin, press the key.
• The origin is changed.
• When changing the origin position in the printer unit, use the [ORIGIN] seal put on the printer unit as a
reference.
• When changing the origin position in the cutter unit, use the tool holder (pen point) of the cutter unit as a
reference.
OR I G I N SE T UP
0.0 ----
OR I G I N SE T UP
0.0 0.0
Origin
(Length)
Origin
(Width)
OR I G I N SE T UP
** ORIGIN **