3-39
Machine Settings
3
Extended Functions – Printer –
● When an error occurs in the Step 6
This function stores the calculated quantity of remaining ink in the ink chip of the 600cc cartridge.
If the 600cc cartridge is removed or there is a problem on the contact of this
device and the ink chip, the data storage in the ink chip cannot be performed.
In this case, the message on the right will be displayed.
If the message is displayed, reinsert the 600cc cartridge and follow the
procedures from the Step 2 again.
Inputting weight of the cartridge after initial ink filling
When the initial ink charging ( P. 6-18) was finished after [DISCHARGE & WASH], the screen to input the
weight of the 600cc cartridge is displayed.
1
When ink filling is completed, the following screen is
displayed.
2
Remove the 600cc cartridge and measure the weight.
• Be sure to measure the weight of the eco case including the 600 cc ink pack.
3
Reinsert the 600cc cartridge.
4
Pressing the keys input the
weight of the 600cc cartridge.
• Press the keys to move to another digit.
• Press the keys to input the weight.
5
Press the key.
6
Press the key.
• If there is a 600 cc cartridge, which the quantity of remaining ink is not set, the screen will return to the
Step 1.
Repeat the procedures from the Step 1 to 6 for all the 600cc cartridges set in this machine.
• When the setting for the quantity of the remaining ink of all the 600cc cartridges is completed, return to the
local mode.
• This machine calculates the available quantity of remaining ink from the weight of the 600 cc cartridge
input in this machine.
Accurately weigh the 600 cc cartridge down to 1 gram unit.
• To input a larger value than the actual weight of the 600 cc cartridge will cause a dot missing by false
control of the remaining ink.
*** 600cc Error ***
Preservat i on fa i lure
InkLevelSet ..C.....
040
0 g
InkLevelSet ..C.....
055
5 g
InkLevelSet ..C.....
0555g OK ? :
e nt
To Next Page
Loading...
