Preparing for the Heaters
2-39
2
Basic Operations
Reference for Temperature Setting
Checking the Heater Temperature
1
Press on the operation panel.
• The current heater temperature is displayed.
2
Press to end the checking.
• The screen returns to LOCAL.
Ink type
BS* ink
Media type
Glossy chloroethylene Tarpaulin FF
Pre-heater setting
35°C 35°C 35°C
Print heater setting
35°C 35°C 35°C
Post-heater setting
50°C 50°C 50°C
• Adjust the temperature appropriately according the state of the medium you use.
• When switching the mode to the print mode after cutting data in the cut mode and pressing the
key, “OFF” is displayed on each heater temperature. When pressing the
key again, the temperature will go up to the set temperature.
PRE PRT POST
35°C 40°C 50°C
To Next Page
Loading...
