3-46
Inputting weight of the cartridge after initial ink filling
When the initial ink charging ( P. 6-18) was finished after [DISCHARGE & WASH], the screen to input the
weight of the 600cc cartridge is displayed.
1
When ink filling is completed, the following screen is
displayed.
2
Remove the 600cc cartridge and measure the weight.
• Be sure to measure the weight of the eco case including the 600 cc ink pack.
3
Reset the 600 cc cartridge.
4
Pressing the keys input the
weight of the 600cc cartridge.
• Press the keys to move to another digit.
• Press the keys to input the weight.
5
Press the key.
6
Press the key.
• If there is a 600 cc cartridge, which the quantity of remaining ink is not set, the screen will return to the
Step 1.
Repeat the procedures from the Step 1 to 6 for all the 600cc cartridges set in this machine.
• When the setting for the quantity of the remaining ink of all the 600cc cartridges is completed, return to the
local mode.
● When an error occur in the Step 6
This function stores the calculated quantity of remaining ink in the ink chip of the 600cc cartridge.
If the 600cc cartridge is removed or there is a problem on the contact of this
device and the ink chip, the data storage in the ink chip cannot be performed.
In this case, the message on the right will be displayed.
If the message is displayed, reinsert the 600cc cartridge and follow the
procedures from the Step 3 again.
Error when performing maintenance function
When performing the maintenance function such as the head cleaning or the ink filling for the 600 cc cartridge,
selected functions can be performed if the quantity of remaining ink is enough to execute the function, even if the
ink near end occurs.
If the quantity of remaining ink is not enough, a message on the right appears,
and selected maintenance function is not performed.
• This machine recalculates usable amount of remaining ink by entering the weight of the 600 cc
cartridge.
• Weigh the cartridge exactly down to the gram. Entering a larger weight than the actual one may cause
dot missing.
InkLevelSet ..C.....
040
0 g
InkLevelSet ..C.....
055
5 g
InkLevelSet ..C.....
0555g OK ? :
e nt
*** 600cc Error ***
Preservat i on fa i lure
*** 600cc Error ***
Shor t age o f i nk .
To Next Page
Loading...
