Test Printing
2-36
Performing Head Cleaning
Head cleaning can be performed in three ways. Select one according to the result of test printing.
NORMAL : When any line is missing
SOFT : When only head wiping is needed (when lines are bent)
HARD : When poor image quality cannot be improved even by NORMAL or SOFT cleaning
1
Press the key in LOCAL to select the
printing mode.
2
Press the key.
3
Press to select a type of cleaning.
4
Press the key.
• The remaining cleaning time is indicated in the lower part of the
display.
• When cleaning has ended, the screen returns to LOCAL.
5
Perform test printing again to check the result.
• Repeat the cleaning and test printing until the result becomes normal.
When 600cc cartridge is used
Q Even when [Ink Level] is displayed, enough ink for head cleaning may remain in the ink pack.
When [Ink Level] appears, see "When [Ink Level] is displayed" in the provided manual "When using
600 cc cartridge" and enter the current weight of the 600cc cartridge.
Q When the remaining ink is not enough for head cleaning
When the remaining ink is not enough for head cleaning, an error
shown on the right appears on the step 3. Replace with a new ink
pack, and then perform head cleaning again.
When image quality is not improved even though head cleaning is repeated:
• Clean the wiper and ink cap. ( P.6-6)
• Wash the nozzle head. ( P.6-11)
• See "When Nozzle Clogging Cannot Be Solved" to improve poor image quality. ( P.6-21)
<LOCAL . 1> [ #01 ]
WIDTH:****mm
CLEAN I NG
TYPE : NORMAL
CLEAN I NG
TYPE : HARD
CLEAN I NG ACT I VE
00 : 00
* * * 600cc Er r o r * * *
sho r t age o f i nk .
To Next Page
Loading...
