8-2
Main Body Specifications
Printer Section Specifications
Cutter Section Specifications
Item CJV30-60BS CJV30-100BS CJV30-130BS CJV30-160BS
Printing head
Method Drop-on-demand piezoelectric print heads
Specification One head
Printing mode
(scanning x feeding)
720 x 540 dpi / 540 or 720 or 1440 x 720 dpi / 540 x 900 dpi /
540 or 720 x 1,080 dpi / 720 x 1,440 dpi / 1440 x 1,440 dpi
Usable inks BS* ink
Ink supply
Supplied from ink cartridges through tubes
Ink cartridge replacement method:
Supplied by toggle switchover with two cartridges per color
Amount of supplied ink Two 600-cc ink packs for each color, 1200 cc per color
Usable media Tarpaulin / FF(Flexible Face) / Polyvinyl chloride film
Dead space
Leaf
medium
Left and right: Inside the pinch roller detection position (default value) /
Front: 40.0 mm / Rear: 98.5 mm
Roll
medium
Left and right: Inside the pinch roller detection position (default value) /
Front: 40.0 mm / Rear: 0.0 mm
Head height adjustment 2.0 mm / 3.0 mm (from the platen surface) 2-step adjustment
Waste ink tank Bottle type (2,000 cc)
Image memory SD-RAM 128 MB
Command MRL-III (MIMAKI original command)
Item CJV30-60BS CJV30-100BS CJV30-130BS CJV30-160BS
Maximum speed
*1
*1. The maximum speed may be limited, depending on the size of a used medium. In addition, the cutting section does not
operate with both speed and acceleration being at the maximum.
30 cm/s
Maximum acceleration 1 G
Cutting pressure 10 to 350 g
Usable tools
Eccentric cutter / water-based ballpoint pen / oil-based ballpoint pen /
Ballpoint pen for handwriting (sold on the market)
*2
*2. Use one with a diameter of 8 to 9 φ whose clamped part has no protrusion or taper. In addition, because the position of the
pen point changes, depending on the types of pens, no good image quality can be ensured.
Number of times the cutter responds
to a medium
10 times/sec
Usable media
Polyvinyl chloride sheet (Thickness of 0.25mm or less with laminate
*3
) / fluorescent sheet
*4
/ reflecting sheet
*4
(excluding high-intensity reflecting sheets)
*3. This conforms with our specified sheet.
*4. When a blade dedicated for fluorescent sheets (SPB-0007) or a blade dedicated for reflecting sheets (SPB-0006) is used
Dead space
Leaf
medium
Left and right: Inside the pinch roller detection position (default value) /
Front: 40.0 mm / Rear: 98.5 mm
Roll
medium
Left and right: Inside the pinch roller detection position (default value) /
Front: 40.0 mm / Rear: 0.0 mm
Repetition accuracy
*5
*5. For repetition accuracy, see the lower part of this page.
± 0.2 mm (excluding the expansion and contraction due to the temperature of the film)
Reception buffer memory SD-RAM 30 MB (20 MB when the sorting function is effective.)
Command MGL- II c2
Program step 25 µm / 10 µm
To Next Page
Loading...
