Mimaki Europe B.V.
Industrial Products
The adjustment of LED_UV lamps alignment
• The alignment of UV lamps needs to be adjusted depending on the printing.
• Loosen the screw of the lamp and slide it to move the UV lamp for right and left of the carriage.
• Suitable timing for changing UV position
• The lamp position should be above setting when you prioritize the image quality, and the lamp position need
to be changed.
(The machine suspends before printing clear ink and the alarm will be shown in RasterLink.)
• If you cannot change the lamp position during the print, please set the lamp position at 0mm before printing.
• With RasterLink6, the following message dialog box may be displayed, then click the [OK] button is clicked
39
Adjust the tip of the arrow to the scale
marks
To Next Page
Loading...
