11
Changing vacuum control unit parameter
• Function code parameter
4. Enable the data protection function of the inverter.
• Return the function code data of the function code “F00” from “0” to “1”.
5. Attach the cover.
Function code Name
Function code data
Default Change value
F01 Frequency setting1 4 1
F02 Operation 2 1
F03 Highest output frequency 60.0 60.0
F04 Base frequency 60.0 60.0
F05 Base frequency voltage 0 200
F07 Acceleration time1 6.00 15.00
F08 Deceleration time1 6.00 15.00
F12 Heat damping time constant 5.0 0.5
F14 Momentary-power-failure reboot 1 5
F15 Frequency limiting circuit maximum 70.0 70.0
F16 Frequency limiting circuit minimum 0.0 8.0
E01 Terminal X1 0 0
E02 Terminal X2 7 1
E03 Terminal X3 8 5
E20 Terminal Y1 0 3.5
C05 Multistage frequency 1 0.00 20.00
C06 Multistage frequency2 0.00 40.00
C07 Multistage frequency3 0.00 60.00
H98 Open-phase protection 3 7
To Previous Page
Loading...
