8
WARNING
Power supply and voltage
• This unit contains parts applied high voltage.Carrying out electrical work by those unauthorized for that work is
prohibited.
• Use it with the displayed power supply specifications. The power-supply voltage of this machine shall be
single-phase 200 to 240 Vac 20 A and less. (You cannot use this machine in the 100V system.)
• To prevent electrical shock, be sure to set OFF the main power circuit breaker and disconnect the power plug
before carrying out maintenance.For some units, capacitors may take one minute for discharging; therefore,
start maintenance work three minutes after setting OFF the main power circuit breaker and disconnecting the
power plug.
• Be sure to carry out grounding work to prevent electrical shock.
• The main power circuit breaker should be set ON only by personnel with sufficient knowledge about operations
of this unit.
• Do not touch the LED UV unit on or right after the lamp off with bare hands to avoid from burn injury.
Handling the Anti-freezing liquid
• Use the exclusive Anti-freezing liquid by Mimaki ,or the LED UV cooling device may be damaged.
• If the Anti-freezing liquid or mixed soft water with anti-freezing liquid gets on the skin or clothes, immediately
wash it off with soap.
If you get the Anti-freezing liquid or mixed soft water with anti-freezing liquid in your eyes, immediately wash
your eyes with a lot of clean water.
Then, consult a doctor as soon as possible.If high temperature Anti-freezing liquid or mixed soft water with
anti-freezing liquid gets on the skin, immediately wash it off with soap and cool with iced water. Then, consult a
doctor as soon as possible.
• Before using the Anti-freezing liquid, be sure to read the Material Safety Data Sheet (MSDS).
• If you swallowed the Anti-freezing liquid or mixed soft water with antifreezing liquid accidentally, try to get to
vomit, and then consult a doctor as soon as possible.
• When unused the Anti-freezing liquid or used mixed soft water with anti-freezing liquid should discard as
followings,
nIncinerating the fluid which is absorbed to the sawdust or waste cloth.
nEntrust them to an industrial waste disposal contractor, clarifying their contents.
• Avoid ignition such as static electricity and impact spark.
• Be sure to wear goggles and gloves for handling the Anti-freezing liquid.
Handling of LED UV unit
• Do not use the LED UV in an ambience with a possibility of catching fire (gasoline, combustible gas spray,
thinner, lacquer, powder dust, etc.). In addition, do not put paper or cloth near or on the LEDUV, or it may
cause fire.or it may cause electrical shock.
• Never look at the LED UV being lit with your naked eyes,or it may cause pain in your eyes or visual
impairment.Be sure to wear safety glasses.
• Do not apply ultraviolet (UV) light directly to your skin,or it may cause irritation on your skin.
• It is recommended to replace the LED UV unit within the rated life.
Disposition of this machine
• When discarding this machine, request the treatment of it for an industrial waste disposal contractor.
• Treat it properly in compliance with regulation in the local area.
To Next Page
Loading...
