Important:
Water-based transportation liquid
(S-46), supplied in the head at the
time of shipment, reacts to solvent ink
and may cause clogging. Therefore,
it is necessary to wash the new head
before proceding with installation.
2-3. Insert hex screws in holes at front and
rear of Head Adjusting Plate.
2-4. Before installing new Head inspect the
area where Head will sit for any debris such
as dried ink. Clean with Solvent (SPC-0336)
if neccessary.
2-5. Grasping damper projection, place
Head in position. Install, but do not tighten
the front and rear hex screws.
2-2. Fill syringe with 6-8 cc of S-Head
Replacement Solution. Inject approx 3-4 cc
into each Damper Insertion Projection over
a period of about 30 seconds. Head can be
damaged if fl uid is injected too fast.
2. Installation of New Head:
© 2005 Mimaki USA Pg. 3/7
2-1. Unpackage new head. Copy down the
new Head ID exactly as it appears on head.
1-9. Head and Adjusting Spring removed.
If head is covered by warranty, fl ush, drain,
place rubber cap over nozzles and package
ready for return to Mimaki USA.
To Next Page
Loading...
