MIMAKI ENGINEERING CO., LTD.
8. Determining to replace HDC FFC 130/160 ASSY
(1) Check whether the reinforcing part (light blue) of HDC FFC 130/160 ASSY connected to the Ink
slider PCB is folded or not. If they are folded, please replace them since the folded FFC may
cause disconnection.
Bad example 1 Bad example 2
Good
Attach the FFC vertically from the connector and have a margin of the curved FFC.
It is bad because FFC are
folded obviously
Disconnection part
Please replace the FFC if it is obviously folded
along the edge of the reinforcing part shown
above.
Electrolytic capacitor C8, C9
Attach the FFC not to exceed the
height of electrolytic capacitor.
Caution:
• Take care not to touch the connecting part of the FFC with your finger and prevent
the FFC from liquid such as ink and washing fluid. If not, contact failure may be
caused.
• If the FFC is slipped and pulled at the outlet of the connecter on the Slider PCB,
when operating [#TEST]-[MOTOR TEST]-[Y SERVO MOTOR] to make the
carriage scan with full-width of the machine continuously, fix the twisted ink tubes in
the cable bear and the position of FFC with keeping the margin of the curve to reduce
slide slip.
6/7 D900674 Ver1.1
To Next Page
Loading...
