MIMAKI ENGINEERING CO., LTD.
7. Checking damage of the Ink slider PCB
(1) Remove 6 FFC at CN1-CN6 on the Ink slider PCB.
(2) Measure resistance between 3.3V pattern and GND pattern in Ink slider PCB and judge whether
it is good or not with List 4.
* Connect the Negative terminal of the tester to the GND test pin (TPG1-4) and measure the
resistance by getting the Positive terminal touch to 5-8 pin of CN3.
* In the case ERROR 200 or ERROR 50 occurred even if replaced the print heads, it is highly
likely that U1 (CPLD, E600074) of Ink slider PCB is damaged.
Ink slider PCB
U1
6 / 8 pin
5 / 7 pin
GND
5-8 pin of CN3
List 4
Test pin
Normal U1 Abnormal U1
CN3-5
CN3-6
CN3-7
CN3-8
5KΩ and more
Good
Less than 5KΩ
Bad
5/7 D900674 Ver1.1
To Next Page
Loading...
