To Previous Page

USA Document#20110329001 JV5/JV33/CJV30 Main PCB replacement guideline

E.E.

E. The

TheThe

There are noises or vibrations occurring on X and/or Y axis and/or error messages

re are noises or vibrations occurring on X and/or Y axis and/or error messages re are noises or vibrations occurring on X and/or Y axis and/or error messages

re are noises or vibrations occurring on X and/or Y axis and/or error messages

relating X/Y axis occur immediately after these noises or vibrations

relating X/Y axis occur immediately after these noises or vibrationsrelating X/Y axis occur immediately after these noises or vibrations

relating X/Y axis occur immediately after these noises or vibrations

1. In case of noises or vibrations occurring, proceed [FUNCTION]－[#ADJUST]－

[MOTOR CURRENT]

2. In case of error messages are occurring, change parameter below

Then proceed [FUNCTION]－[#ADJUST]－[MOTOR CURRENT]

JV5 series

MAINTE PARAMETER No.61 [PRMsw] → １

MAINTE PARAMETER No.62 [DEBsw] → ３

ADJUST PARAMETER No.0 [MTRCURX] → １４０

ADJUST PARAMETER No.1 [MTRCURY] → １４０

JV33 series

MAINTE PARAMETER No.61 [PRMsw] → １

MAINTE PARAMETER No.62 [DEBsw] → ３

ADJUST PARAMETER No.0 [MTRCURX] → １３０

ADJUST PARAMETER No.1 [MTRCURY] → １３０

CJV30/TPC

MAINTE PARAMETER No.61 [PRMsw] → １

MAINTE PARAMETER No.62 [DEBsw] → ３

ADJUST PARAMETER No.0 [MTRCURX] → １３０

ADJUST PARAMETER No.1 [MTRCURY] → １３０

F.F.

F. Capping/Wiper position off or Cleaning function failure

Capping/Wiper position off or Cleaning function failureCapping/Wiper position off or Cleaning function failure

Capping/Wiper position off or Cleaning function failure

Proceed [FUNCTION]－[#ADJUST]－[CAPPING]

G.G.

G. Any other

Any other Any other

Any other adjustment

adjustmentadjustment

adjustment

problems

problemsproblems

problems

[FUNCTION] － [#ADJUST] and proceed whatever adjustment relating to your

problems

H.H.

H. Any other print setting differences such as heater temp., overprint and so on

Any other print setting differences such as heater temp., overprint and so onAny other print setting differences such as heater temp., overprint and so on

Any other print setting differences such as heater temp., overprint and so on

[FUNCTION]－[SETUP] for JV5/JV33/CJV30

[FUNCTION]－[MACHINE SETUP] for JV5/JV33/CJV30