4. Consumable Item Replacement
29
Media edge guide film replacement
Replace the media edge guide film if it is creased or worn.
1
Remove the media from the take-up unit.
2
Remove the media edge guide film from the media edge guide.
• Make sure no parts of the double-sided tape remain.
3
Remove the double-sided tape on the media edge guide film and attach it to the media edge
guide.
• Align and attach the film hole (×2) to the screw hole (×2) of the media edge guide.
Media edge guide film L
Media edge guide L
Media edge guide film R
Media edge guide R
Waste Ink Tank Replacement
Ink used during head cleaning and other processes is collected in the waste ink tank at the lower right of the
product.
This product keeps track of the waste ink level. A “Check Waste Ink Tank” message appears when the
preset level is reached. Use this a guide for replacing the waste ink tank.
• For a 2-liter tank, the preset level is 80 % (1.6 liters).
• Continuing to use the product without disposing of the waste ink may result in waste ink
overflowing from the waste ink tank. Visually check ink levels in the waste ink tank about once a
week.
• Pay close attention to ventilation and be sure to wear safety glasses, gloves, and a mask when
handling ink, maintenance liquid, waste ink, or other solutions used with this machine. Leaking
ink may adhere to the skin or get into the eyes or mouth.
When “Check Waste Ink Tank” message appears
1
The “Check Waste Ink Tank” message appears on the display.
2
Check the waste ink levels in the waste ink tank.
• If you note any discrepancies from actual levels, proceed to the next step.
• If there is no discrepancy, replace (dispose of) the waste ink tank referring to "Replace the
waste ink tank."(P. 30).
To Next Page
Loading...
