MIMAKI TS330-1600 - Page 155

Chapter 5 Using the XY Slitter
155
14
Position the media guides.
Set media guides
[ENT]
Media guides
Media guides
Position the media guides 10 to 20 mm away from the media
edges.
Position media guides in blank space. The blank pieces cut off
will be ejected to the media chute.
RasterLink [Y Slit] setting: [Normal] [Line Space] RasterLink [Y Slit] setting: [Nothing]
15
Press the [ENTER] key.
• Slitting starts.
Width (R) : 500 mm
Width (L) : 500 mm
Start [ENT]
• Slitting is repeated until reaching the end of the media. To stop slitting, press the [END]
key.
5