Chapter 7 Maintenance
194
• If not, use a syringe to draw up some maintenance liquid and fill until it almost overflows
from the cap.
7
Close the maintenance covers.
8
Set the exposure time, then press the [ENTER] key.
• Cleaning is performed automatically once print nozzle washing has ended.
• The cap is filled with maintenance liquid.
9
Open the maintenance cover on the right side.
• Check to confirm that the cap is filled with maintenance liquid.
• If not, use a syringe to draw up some maintenance liquid and fill until it almost overflows
from the cap.
10
Close the maintenance cover, then press the [ENTER] key.
• Pump tube (ink discharge channel below the cap) washing starts.
To Next Page
Loading...
