Chapter 7 Maintenance
219
• Pen line rubber
Used for pen writing or cutting
• Pen line sponge
Used for half cut (cutting across a dotted line)
• JV/TS: Feature not included.
• Turn off the main power supply and unplug the power cable before replacing the pinch rollers.
1
Open the front cover.
2
Use tweezers to peel off the end of the pen line.
• Wipe off any adhesive remaining in the platen slot with industrial alcohol.
3
Attach double-sided tape in the platen slot.
• Peel off the base paper from the double-sided tape.
4
Attach the pen line on the double-sided tape.
• Make sure the pen line lies flat.
5
Close the front cover.
7
To Next Page
Loading...
