9
10. Periodically care (Once a week)
Users are advised to perform the maintenance works described below once a week so that the printer will
keep its high performance and accuracy over an extended period of its life.
(1) Exterior (“Cleaning the Exterior Surfaces” “Cleaning the table” Chapter 4, Operation
Manual)
Depending on the using environment, the dusts or sand powder could stick to the exterior of the main unit. To
avoid the entry of the dusts into the moving part of the head, wipe them off with soft cloth dipped into water
and squeezed tightly.
(2) Bottom of LED lamp and bottom of mist filter (“Clean the bottom of the LED lamp
and the bottom of the mist filter” Chapter 4, Operation Manual)
1
Move the carriage to the left and open the maintenance cover.
• Refer to the Step 1 to 5 of Chapter 4 “Clean the bottom of the LED lamp and the bottom of the mist filter”
of the user’s manual to perform the operation.
2
Clean the bottom of the LED lamp and the bottom of the mist filter.
●When it is very dirty
(1) Soak the cleaning stick in the maintenance liquid.
(2) Clean the ink which is adhered to the bottom of the LED lamp and the bottom of the mist filter with
the image of gently tapping.
●When there is dust on it
(1) Place the tape with weak adhesive strength (drafting tape, etc.) on the relevant part.
(2) Lightly press with your fingers.
(3) Peel off the tape.
• Execute multiple times as needed.
• Do not rub. The low reflection treatment may peel off.
• The power to press the tape should not be too strong.
The low reflection treatment may peel off.
To Next Page
Loading...
