12
12. Replacing consumables
To order replacement consumable items, contact your local dealer or our service office.
For more information on other consumable items, refer to our website.
https://mimaki.com/supply/inkjet.html
(1) Replace wipers/ wiper absorbers (“(When using rubber wiper) Replace the wiper/
wiper absorber.” Chapter 4 of the Operation Manual)
The wiper and the wiper absorber are consumable. When the display indicates the warning message
“!REPLACE WIPER/ABSORBER”, it is necessary to check and replace the wiper and wiper absorber immedi-
ately with a new one.
Also, wipe ink sticking to the lower surface of the slider off.
(2) Replace the nozzle cap(“(When using suction wiper)Replace the nozzle cap” Chapter
4 of the Operation Manual)
If the nozzle cap is badly scratched or dirty, replace it by referring to Chapter 4 "Replacing the Nozzle Cap" in
the User's Manual.
(3) Replacing the mist filter (“Replacing the mist filter” Chapter 4 of the Operation Man-
ual)
If the stain is strong, please replace the filter referring to the Operation Manual Chapter 4 “Replacing the mist
filter”.
(4) Replacing the mist filter box (“Replacing the mist filter box” Chapter 4 of the Opera-
tion Manual)
If the stain is strong, please replace the mist filter box referring to the Operation Manual Chapter 4 “Replacing
the mist filter box”.
(5) Replacing the LED Glass (“LED Glass Replacement” Chapter 4 of the Operation Man-
ual)
If the stain is strong, please replace the LED Glass referring to the Operation Manual Chapter 4 “LED Glass
Replacement”.
• When the warning message for replacing wiper is shown, confirm whether there is no damage and
fuzz at the top edge of the wiper film. If there is no damage on the top edge of the wiper film, it is
possible to use the wiper continuously without replacing it. Also, if ink is not accumulated in the wiper
absorber, use it as it is.
• A cleaning wiper is an option. Please buy one through the dealer in your region or at our service
office.
To Next Page
Loading...
