5
(5) Media press (“Cleaning the Media Press” Chapter
4 of the Operation Manual)
When the cut dust of the media and other dusts accumulate
between the media holder and the platen, it could cause the
risks that the transfer of the media could not be performed prop-
erly or such dusts stick to the nozzles and this could interfere the
proper printings. You are recommended to clean it frequently.
(6) Media sensor ("Cleaning the Media Sensor" Chapter 4 of the Operation Manual)
The media sensors are located on the platen (for two positions) in the backside and the bottom surface of the
head.
If the dusts and ink accumulate on the sensor, it could cause false detection of the media or the register mark.
Wipe off the sensors with soft cloth or clean sticks.
(7) Waste ink tank ("Discarding waste ink" Chapter 4 of the Operation Manual)
Refer to the Chapter 4 “Discarding waste ink” of the user’s manual to perform the operation.
• For the cleaning of the media sensors, never use the solvent.
• When the sensor is heavily stained, wipe off with a cloth soaked in the waterdiluted neutral
detergent.
• When cleaning the media sensor at the bottom of the head, be cautious of the cutter blade near the
sensor to avoid injuries.
To Next Page
Loading...
