These guidelines do NOT replace the instructions for use and all users should refer to the appropriate Operator’s Manual for detailed instructions.
The Illustrations may not necessarily reflect the setup or data displayed on your device.
BeneHeart R3 Clinical Education Pack SWL 02.07_V1 Mindray UK © 2020. Errors and omissions excepted. Subject to change.
Mindray® is a registered trademark of Shenzhen Mindray Bio-Medical Electronics Co. Ltd.
18
Rhythm Measurement*
In rhythm measurement mode, the device acquires 60 seconds of data then prints the waveforms of
the rhythm lead.
In the rhythm ECG report, ECG waveforms are displayed in 3 cascade lines, with each line including 10
seconds of waveform.
You can change the lead to be recorded in the rhythm report by selecting [Menu] →[Report
Setup]→[Rhythm Lead].
To generate a rhythm report:
1. Follow steps 1 to 4 of Auto Measurement above.
2. Press the [Rhythm] key to start a rhythm measurement.
The device will start acquiring ECG data and display a countdown. When 60 seconds of data has been
collected printing will start automatically.
The rhythm mode automatically stops when the report is finished. You can also press the [Rhythm]
key to manually interrupt it.
*Please note that in rhythm measurement mode no analysis of the waveforms will be made by the
device.
To Next Page
Loading...
Need help?
General
