These guidelines do NOT replace the instructions for use and all users should refer to the appropriate Operator’s Manual for detailed instructions.
The Illustrations may not necessarily reflect the setup or data displayed on your device.
BeneHeart R3 Clinical Education Pack SWL 02.07_V1 Mindray UK © 2020. Errors and omissions excepted. Subject to change.
Mindray® is a registered trademark of Shenzhen Mindray Bio-Medical Electronics Co. Ltd.
9
Below are the advised initial setup steps. The options suggested are in addition to the existing
selections in the default configuration unless otherwise stated. Following these steps before the first
use will ensure the most effective default configuration for the majority of users.
If your device has already been configured, skip this section and move to Section 8: Patient
Demographics.
Set Patient Information
• On the operating panel select [Menu].
• Use [F3] to scroll down to [Basic Setup].
• Press [F4] Enter.
• Select [Patient Info Setup].
• Press [F4] Enter.
• First select [Detailed Patient Info]. This allows you to decide which details can be included when
the Patient ID key is pressed. (Basic information of ID, name, gender and age included as default).
• Use [F2] and [F3] to scroll through the menu, followed by [F4] to make your selections.
*Advised selections: [DOB] and [V3 Placement]
• Next select [Required Patient Info]. This creates a prompt to input the Patient ID (Hospital
Number) when the ECG key is pressed, ensuring all recordings are labelled.
• Press [Enter].
• On completion select [F1] Back to return to the previous menu.
Set Date and Time
• On the operating panel select [Menu].
• Use [F3] to scroll down to [Basic Setup].
• Press [F4] Enter.
• Use [F3] and [F4] to scroll to required menu item, e.g. day, month or year.
• Press [F4] Enter.
• Use [F2] and [F3] to until desired option is reached.
• Press [F4] Enter.
The highlighted area will now automatically move onto the next field. Continue with this process until
all date and time settings are correct.
• For [Lead Notation] select [IEC].
• Choose your preferred selections for [Auto Standby] and [Auto Shutdown].
• Press [Back] to return to the previous menu.
Section 6
Advised Setup
To Next Page
Loading...
Need help?
General
